|
Step 1.- Clean substrate of all contamination,
such as grease, dirt and oils using isopropyl alcohol/detergent
or other appropriate cleaning solutions
Step 2.- Pla-Stick is ready to spray
as packaged, no reduction is needed. Apply one medium
coat of Pla-Stick with a dry film thickness of 0.1 to
0.2 mils using standard spray equipment.
NOTE: Proper coat thickness is critical
for good adhesion properties. With adhesion promoters,
more is not better. Carefully monitor coat thickness.
Basecoats or primers may be applied immediately after
the Pla-Stick coat has dried, usually within 2 to 3 minutes
at temperatures 70° F or above. Pla-Stick acts as
an adhesive to the plastic providing a bond.
Step 3.- Clean equipment thoroughly
with thinner. |
